Saeshin Strong 207a/h400 router

Strong 207a, along with 207s, is one of the most powerful control units in the manufacturer's line. It produces as much as 125 W of power, has electronic "brains" that are periodically included in the work and help the master, throwing torque on the micromotor so that your "assistant" does not stall at low speeds. The control unit is distinguished by its laconic design, each button is in its place. On the front panel are the On/Off buttons, the cutter speed regulator, and the reverse switch toggle switch. The power button has a special "casing" to protect against dust. The cutter can work both with and without a pedal. Now about the Strong H400 handle. The tip in this configuration does not lag behind the unit in terms of its parameters. The H400 micromotor is the older brother of the 107ll handle. Having the same technical characteristics, the Strong H400 handle has a number of advantages. It is equipped with reinforced metal-ceramic bearings, the resource of which is greater than that of its younger sister. Also, there are additional seals inside the micromotor that prevent dust from entering. This tip is ideal for masters who work a lot with their feet and do pedicures. But there is a small minus, the H400 handle is somewhat heavier.

Now let's go through the technical characteristics of the mill. The device produces 125 W of power at a torque of 4 N/cm. This means that the mill is ideal not only for manicure, but also for pedicure.

The micromotor is equipped with a cooling system, which is immediately felt during operation. A pleasant stream of cool air flows along the tip. The handle is equipped with a collet mechanism for clamping the mill "Twist lock". The time to change the nozzle takes no more than 2-3 seconds.

Absolutely all Strong devices are equipped with overload protection. This means that the electronics will sense when you are overexerting your "assistant" and will intervene at the right moment and turn off the router. After giving the device a few minutes to rest, you can continue to use it. There is also a switch on the control unit body from 220 Volts to 110. This function is relevant only for craftsmen living in the USA, Canada, and several other countries around the world. Craftsmen from Ukraine do not need to switch anything there! otherwise the power supply will simply burn out in a matter of seconds!

Technical characteristics: